Colour Sensor - Q6651-60271 Q5669-60684 CH955-67101 Refurb

Colour Sensor ESP (Spectrophotometer)

Part Number:
Q5669-60684   /   Q6651-60271

--------------------------------------------------------------------------------

SOL Spectrophotometer:

 - SOL is a colour sensor and it is placed in the left side of the Carriage Assemble.  The main function of SOL is to measure colour samples that have been printed on the loaded media and are placed on the print platen zone.

- Before taking any colour measurement, SOL must be initialized. The SOL initialization process lasts for about 7min. This process consists of 3 steps: sensor switch on, sensor warm up and sensor calibration.

- When the initialization has been completed, the shutter is opened automatically and the Carriage Assemble is moved along the scan axis to place SOL on top of each sample to take a colour measurement. After the measurements, the shutter is closed again and the Colour sensor is switched off.

- SOL is used for colour calibrations in printer. The colour calibration process consists on printing a colour pattern, scanning the printed pattern using SOL and finally some internal algorithms adjust printer colours taking into account the obtained data.

Error code: 58:10 - Problem with the Color Sensor:

An error detected with the Color Sensor.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer.
• Check that the Printer has the latest Firmware version, if not, update the firmware to the latest version.
• Replace the Colour Sensor